Jet jdp-17mf drill press manual

BP-1, Stock No. Floor Drilling Capacity MT-2 Column Diameter Head Assembly 1. Table 1. Column and Bracket Assembly 1. Base 1. Warranty Registration Card 1. Chuck and Chuck Key 3. Downfeed Handle 1. Table Bracket Lock Handle 1. Table Bracket Raising Handle 4. Page Assembly Assembly 1. Place the base A, Fig. With a 17mm wrench attach the column assembly B, Fig. Tighten firmly. With the aid of a second person, carefully lift the head onto the column top.

The head assembly is heavy! Use care when lifting onto the column! Rotate head assembly until sides of the belt cover are parallel with the sides of the base. Page Adjusting The Depth Stop 1. Use a pencil to mark the depth the bit will drill into the workpiece A, Fig.

With the drill bit in the chuck, lower down feed handle to advance bit to your mark,see Figure 7. Page Return Spring Adjustment Return Spring Adjustment The return spring is adjusted at the factory and should need further adjustment. Unplug the machine from the power source. Loosen two jam nuts A, Fig. Do not remove. Firmly hold the coil spring cover B, Fig. Page Basic Operation Feeding too slowly may cause burning of the workpiece.

Page Troubleshooting 4. Tighten set screws in pulleys. Change to appropriate speed, see speed and pulley chart, page Retract drill bit frequently to remove chips.

Resharpen, or replace drill bit. Increase feed rate. Resharpen bit correctly. Column and Holder Assy.. Set Screw New Products.

Mortisers Grinders Scroll Saws Accessories. Stay Connected Be the first to know about new products, events and special offers. Roll over Image to Zoom. Stock No. Contact An Expert. Features X pattern mounting grooves in table allow mounting a fence when table is in reverse position 16 Speeds lets you choose the best speed for the job Adjustable tension spindle return spring Adjustable tension spindle return spring is ideal for repetitive drilling of the same depth Built-in work light bulb not included provides additional visibility of your work.